Measuring Accessory Related Commands
Commands to read out serial numbers and types of measuring accessory connected to the device.
SYST:INPA:SERN?
Request for the serial number of accessory connected to Input A (In A).
SYST:INPA:TYPE?
Request for the type of accessory connected to Input A (In A).
SYST:INPB:SERN?
Request for the serial number of accessory connected to Input B (In B).
SYST:INPB:TYPE?
Request for the type of accessory connected to Input B (In B).
SYST:INP:CONF:STAT?
Request for inputs changing status. Answer is 0 when the configuration has been changed (stable
state), and 1 when the configuration is being changed (in progress).
SYST:INP:CONF {<x>}
Setting the measuring inputs combination. Parameter can have the following values:
x=0 when only internal voltage and current is being measured, regardless of connected measuring
accessory
x=1 when accessory connected to Input A is measured together with internal voltage
x=2 when accessory connected to Input B is measured together with internal current
x=3 when only accessories connected into Inputs A and B are measured, regardless of generated
voltage or current
These measured values are shown on blue screens and corresponding blue type screens are visible
for each particular combination: Load Values when U and I are measured together, U+U screens when
voltages only are available, etc.
SYST:INP:CONF?
Request for inputs configuration. Answer can be 0 ÷ 3 with the same description as for previous (setting)
command.
Results Reading Commands
RES:COUN:EMER?
Request for number of stored meters.
RES:COUN:LP? {<emer (1-255)>}
Request for number of stored load-points of defined meter.
RES:GET:EMER? {<emer (1-255)>}
Request for all header data of defined meter.
RES:GET:LP? {<emer (1-255)>},{<lp (1-255)>}
Request for all load-point data of defined meter and load-point.
RES:CLR
Clearing of all results (stored meters data).
To Next Page
Loading...
Need help?
General
