•
Remove the swingarm pin (10) from
the right side of the vehicle, taking care
to recover the spacer (11) which is lo-
cated between the swingarm and the
right rider footrest support.
•
Remove the complete swingarm (12).
•
If necessary, to check or eventually replace the roller bearings in the swingarm, remove the
bushes (13) and the thrust washers (14).
•
Remove the 4 gaskets (15).
•
Using a suitable punch, remove the
roller bearings.
Specific tooling
020376Y Adaptor handle
020441S 26 x 28 mm adaptor
Checking
CAUTION
Chassis RS 660 - Tuono 660
CHAS - 300
To Next Page
Loading...
Need help?
General
