Aqara Motion Sensor P1 User Manual

05
3.Stick holder pedestal in the required area, and press hard
and evenly for 30 s to make sure it sticks firmly. In the case
of installing on a wall surface, it is recommended that the
holder gap faces upward to facilitate adjusting detection
direction.
1.Choose an appropriate installation position and make
sure installation surface is clean and flat.
Installation with Holder
2.Stick the sensor to the installation pedestal, and press
hard and evenly for 30 s to make sure it sticks firmly.

Aqara Motion Sensor P1 Specifications

General

Detection Angle	170°
Battery Type	CR2450
Battery Life	Up to 2 years
Connectivity	Zigbee 3.0
Operating Humidity	0-95% RH (non-condensing)
Model	RTCGQ-13LM
Compatibility	Apple HomeKit, Aqara Home, Alexa, IFTTT
Detection Distance	Up to 7 meters (23 feet)
Mounting	adhesive