Aqara Motion Sensor P1 - Direct Installation

04
1.Choose an appropriate installation position and make
sure the installation surface is clean and flat.
Direct Installation
*Recommended installation height is 1.2-2m. The detection scope gets
smaller if it is lower than 1.2m. There will be a blind zone at the bottom of
the motion sensor if it is installed higher than 2m.
2.Put the sticker on the bottom of the battery cover,
determine the detection direction, stick it to the desired
installation position, and press hard and evenly for 30 s to
make sure it sticks firmly.
Effective detection area: Top view
6m 6m0m
7m