Why AQUA FORTE Heat Pump display normal but no heating?
If your AQUA FORTE Heat Pump's display is normal but there's no heating, it might be due to the set temperature being too low. Try setting a proper heating temperature. Also, some models have a 3-minute start delay, so wait patiently to see if it begins heating.
What to do if AQUA FORTE MR. PERFECT SC965 fan running but with insufficient heating?
If your AQUA FORTE Heat Pump fan is running but there's insufficient heating, check for a blocked evaporator or air outlet and remove any obstacles. Also, some models have a 3-minute start delay, so wait patiently.
How to fix AQUA FORTE MR. PERFECT SC965 Heat Pump that doesn’t run?
If your AQUA FORTE Heat Pump doesn’t run, first ensure that it has power and the power switch is on. Check the fuse; if it's burned, replace it. Also, verify that the breaker is on. If there was no power, wait until the power recovers.
General warnings about hazards, procedures, and important safety signs.
Instructions for safe installation, use, and maintenance, avoiding unauthorized methods.
Safety practices for power, lightning, ventilation, and handling R32 gas.
Emphasizes professional installation and minimum clearance requirements.
Specifies the need for hard pipes and warns against soft pipes for water connections.
Critical safety notes on power supply, earthing, wiring, and leakage protection.
Explains the purpose of each button and symbol on the control interface.
Step-by-step guide for screen lock, power, temperature, and mode settings.
Essential checks before operating the heat pump for the first time.
Safe procedures for detecting refrigerant leaks and precautions.
Steps for the first operation, including pump start and noise checks.
Precautions for maintenance, especially with R32 gas, and avoiding self-repair.
General| Type | Heat Pump |
|---|---|
| Heating Capacity | 9.65 kW |
| Cooling Capacity | 6.5 kW |
| Noise Level | 42 dB(A) |
| Power Supply | 220-240V, 50Hz |
To Next Page
