How to troubleshoot Aqua PRO Heat Pump that does not run?
If your Aqua PRO Heat Pump does not run, check the following: Ensure that there is power available. If there was a power outage, wait until the power recovers. Make sure the power switch is turned on. Inspect the fuse and replace it if it's burned. Finally, verify that the breaker is on, and if it is off, turn it on.
What to do if Aqua PRO ECO550 Heat Pump is running but not heating?
If your Aqua PRO Heat Pump is running but not heating, first ensure that neither the air inlet nor the air outlet is blocked by any obstacles. Clear any obstructions you find. Also, the unit may be in a 3-minute protection mode; wait patiently for it to complete. Finally, check that the set temperature isn't too low, and adjust it to a more appropriate heating temperature.
Diagram illustrating water pipes connection for the heat pump.
Diagram showing the electrical connections for the heat pump.
Covers general requirements for installation, including ventilation and foundation.
Details on connecting power supply, grounding, and wiring practices.
How to power the unit on/off and set the desired water temperature.
Instructions for selecting Silence mode and using the heating mode.
How to set up the timer for automatic operation.
Explains display icons and how to set the unit's time.
Detailed steps for configuring the timer to turn the unit on and off.
How to activate Silence mode and initiate compulsory defrosting.
Pre-operation checks for installation and connections.
Procedures for the initial startup and testing of the heat pump.
Key operational considerations and advice for efficient use.
Critical safety instructions for users, covering various scenarios.
Steps for winterizing the heater when not in use to prevent damage.
Guidelines for cleaning the unit and regularly checking its components.
To Next Page
General