STEP 4
• Leave the side panel facing upward and position one
of the lock caps (I) centered over any hole on the
side panel.
• Using a small rubber mallet or a (block of wood and
a small hammer), tap on the locking cap until it is
secured over the pin sticking through the side of the
step and is flush with the side panel.
• Repeat this procedure for each of the additional
seven openings on this side of the step.
• Flip step so that other side panel is facing upwards
and repeat above for the eight holes on this side.
6
STEP 5
• Leave the side panel facing upward and
position one of the bases (E) under the side
panel with the channel against the step.
• Secure the base to the side panel with
two zip ties. There is a molded groove
in the base for placement of the zip tie.
Tighten zip tie securely.
• Repeat for opposite side.
NOTE
To prevent damage to liner, make sure that the locking tab on zip
tie is positioned so that it will NOT come in contact with liner.
NOTE
Zip tie should catch and lock when pulled tight, if it does not then
turn the zip tie over and reattach.
To Next Page
Loading...