EasyManua.ls Logo

Aqua Select 832406 - Gate Closer Operation and Safety; How to Set Tension; Safety Information; Maintenance Recommendations

Default Icon
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
When lifting heavy or awkward loads, it is suggested that two people lift to avoid injury.
DO NOT use the pool entry system for any purpose other than that for which it is intended.
Maximum weight on steps should NOT exceed 350 lbs.
MAINTENANCE
Step/ladder/bridges must be removed for winter, failure to do so can cause the step to crack.
When removing step/ladder/bridges for winter, it is recommended that you spray down step
with hose water to rinse off any chemical residual prior to storing.
When storing step/ladder/bridges for winter, it should be protected from the elements and
stored either in a shed or garage, or covered with a tarp.
HOW TO SET TENSION
Turn the center hole away from the
door with the steel bar supplied.
Remove the steel bar
and allow arm to close.
To increase or decrease the tension, repeat the above steps one hole at a time
until the desired tension is found.
Screw the arm into the hole
nearest the gate.
SAFETY INFORMATION
WARNING
Do not over tension the closer. Over tensioning will cause the
spring to buckle and the gate to slam shut and could case damage.

Related product manuals