Aqua A-POOL TOP EVO PH-CL

Need help?

Do you have a question about the Aqua A-POOL TOP EVO PH-CL and is the answer not in the manual?

Summary

Introduction to the A-POOL TOP EVO PH-CL System

Terminal Block Connections

Panel Connections and Wiring

User Interface and Basic Settings

AE Start Programmation: pH Probe Calibration

Initial steps for calibrating the pH probe using the AE Start controller.

pH Measurement and Control Modes

pH Probe Calibration Procedure

Detailed steps for calibrating the pH probe.

ON-OFF Control Mode

Configuration for the ON-OFF dosage control mode.

Proportional Control Mode

Configuration for the proportional dosage control mode.

Time-Pause Control Mode

Configuration for the time-pause dosage control mode.

Pt-Cu Probe Calibration

Pt-Cu Probe Calibration Steps

Detailed procedure for calibrating the Pt-Cu probe.

Output mA and Alarm Configuration

Output mA AE Start Chlorine Programmation

Setting the 4-20mA output for chlorine measurement.

Output mA AE Start PH Programmation

Setting the 4-20mA output for pH measurement.

Range Alarm Programmation

Configuration of range alarms for the system.

Relay and Flow Alarm Settings

Relay2 NC (Normally Closed) Alarm Configuration

Relay2 Alarm Mode Configuration

Flow Alarm Programmation

HC151 Programming and Working Modes

HC151 Default Programmation

Level Alarm Programmation

mA Working Mode Programmation

Configuration of the mA working mode for the controller.

Pt-Cu Probe Maintenance Procedures

Pt-Cu Probe Maintenance

Procedures for maintaining the Pt-Cu probe.

Cleaning Procedures and Chemical Compatibility

Filter Cleaning Procedure

Electrode Cleaning Procedure

Instructions for cleaning the Pt-Cu probe electrodes.