AquaCraft 290050 User Manual

290050
Battery Installation
Basic Setting
Programming
Install 2 AA Alkaline batteries by removing the battery holder from the back of the timer
and inserting the batteries as indicated. Replace the battery holder back.
1. Set Current Time
Pushing button to decrease / increase time to the current time
Pushing or button to confirm.
Recycle batteries after use.
Clock is set on 12-hour time. To change to 24-hour time, press for 10 seconds.
To return to 12-hour time, press for 10 seconds again.
Note: you must at least set one watering day to move to the next step.
Pushing or to next step.
Please change fresh batteries if the battery low indicator
appear on the LCD display.
2. Set Current Day
Pushing button to move the indicator to today’s day of week. (e.g. “TU” for
Tuesday). Pushing or to conrm
3. Select Water Day
There are 3 kinds of watering day setup for better selection.
A. Fixed weekday watering
Pushing to move the ashing tear drop to the desired watering day
of the week.
Pushing to conrm or cancel the watering day of the week.
Repeat the steps until “SA”.
B. Every other 2 days watering
Pushing to move the ashing tear drop to the position “2nd”.
Pushing to conrm. It will automatically set water day for every 2 days.
C. Every other 3 days watering
Pushing to move the ashing tear drop to the position “3rd”.
Pushing to conrm. It will automatically set water day for every 3 days.
1. Select Water Cycle 1
A. Pushing to move the indicator to “1”.
Pushing or to conrm to start setting up the 1st watering cycle .
B. Set Start Time
Pushing to decrease / increase time to the required watering start time.
Pushing or to conrm to next step.
C. Set How Long
Pushing to decrease / increase the duration (up to 240 minutes).
Pushing or to conrm to next step.
D. Activate Eco Function: simply set up WATER and PAUSE MIN.
a. Set up WATER MIN:
Pushing to decrease / increase the WATER duration
(the maximum interval is 19MIN).
b. Set up PAUSE MIN:
Pushing to decrease / increase the PAUSE duration
(the maximum interval is 19MIN).
The Eco Function creates a pause watering cycle, which provides absorption time
for the soil. It can also prevent water run-o.
WATER MIN and PAUSE MIN can be customized according to dierent applications
(e.g. irrigation or lawn & garden), landforms (e.g. at or mountain slope) and soil
density (e.g. high as soil or low as sand).
3 examples and suggestions as below:
a. Irrigation: WATER 5 MIN PAUSE 2 MIN
b. Lawn – at: WATER 4 MIN PAUSE 1 MIN
c. Lawn – slope: WATER 2 MIN PAUSE 2 MIN
Note: you can skip this setting if not needed.
TIME
TODAY
WATER DAY
ZONE
WATER CYCLE
START TIME
HOW LONG
ECO FUNCTION
PROGRAM
OK
Electronic Water Timer

AquaCraft 290050 Specifications

General

Brand	AquaCraft
Model	290050
Category	Lawn and Garden Equipment
Language	English

Summary

Basic Setting

Set Current Time

Set the current time displayed on the water timer, with options for 12-hour or 24-hour format.

Set Current Day

Select the current day of the week to ensure accurate watering schedules.

Select Water Day

Choose the watering frequency: fixed weekdays, every 2 days, or every 3 days.

Programming

Select Water Cycle

Configure watering cycles, including start time, duration, and Eco Function settings.

Manual Watering

Disabling the Program

Activate Programming

Rain Delay

Installation

Care and Maintenance