Need help?Do you have a question about the Aquadeck Tube motor and is the answer not in the manual?
Steps to fit the motor flange.
Steps to fit the bearing flange.
Steps to fit the winding tube.
Steps to fit the wall duct.
Steps to fit the bearing flange.
Steps to fit the winding tube for wall duct installation.
Steps to fit suspension plate on the motor side.
Steps to fit suspension plate on the bearing side.
Steps to fit the winding tube for suspension system.
Steps to fit pre-assembled element on motor side.
Steps to fit pre-assembled element on bearing side.
Steps to fit flanges after liner installation.
Steps to fit the winding tube for pre-assembled elements.
Steps for attaching pool cover slats.
Steps for fitting directional guide brackets.
Steps for detaching pool cover slats.
Connection diagram for cable duct/suspension systems.
Connection diagram for wall duct/cast-in systems.
Table showing slat roll diameters based on pool length.
Diagram and table for in-pool niche dimensions.
Guidelines for operating the pool cover.
Safety precautions for cover operation and installation.
Guidelines for winter storage of the slatted cover.
Instructions for storing solar/transparent pool covers.
Guidelines for fitting solar/transparent pool covers.
Maintenance for cover on water during operation.
Importance of water level for cover cooling and deformation.
Requirements for rolled-up covers to prevent deformation.
Steps for cleaning pool cover slats.
Precautions when emptying the pool with a cover.
General| Brand | Aquadeck |
|---|---|
| Model | Tube motor |
| Category | Lighting Equipment |
| Language | English |
To Next Page