CAUTION!
The power must be disconnected before the pump is handled.
The pump must be entirely immersed in water when it is used.
The pump must never be lifted by the cable.
Hot uid must never be pumped (maximum 30° C).
Only fresh water may be pumped.
The pump must not be operated without the supplied pump cage
Only turn on mains power once pump is in position
USE
A clogged or dirty intake will put a strain on the motor and greatly reduce the pump’s performance.
If the base on which the pump is to be stood is very dirty, raising the pump slightly will reduce the
amount of debris surrounding the intake of the pump. If decreased ow is desired this can be adjusted
with the control on the side of the pump or through limiting the outow.
The pump should not be used when it is not immersed in water since it can be damaged.
Only connect the power once immersed in water. When rst installed there may be air trapped in the
pump and tubing, this can be dispersed by turning the pump on and o several times
MAINTENANCE
To clean the pump remove the impellor housing and impellor. Use clean water and a small brush to
remove debris. Never use harsh cleaners or chemical solutions for cleaning the pump (this may cause
permanent damage)
OBSERVE: It is not possible to remove the axle.
Maintainance
Use only fresh water in this pump.
Little maintainance is necessary if the pump is used according to the instructions in this manual.
If dirt builds up in the intake, rinse using running water but remember to always unplug from the
power rst. A 30mA (or less) Residual Current Device (RCD) must be tted to the mains supply.
Warning!
• Never connect to a power supply with dierent voltage and current than that stated on the pump's label.
• Never pump ammable uids through the pump.
• National electrical regulations require that a ground fault circuit interrupter (GFCI) is used in
direct connection to equipment that is used in water. See your electrical supplies outlet for this device
• Do not use the pump in waters that exceed 30°.
Regulator
Front cover impeller seating
rotor
Shaft
Seal ring
Impeller
Shaft cover
Plug
To Previous Page
Loading...
