EasyManua.ls Logo

Aquallice ASPIRE 75 - User Manual

Default Icon
16 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
bomba autoaspirante
para piscina
MONOFÁSICA
ASPIRE

Table of Contents

Questions and Answers

  • R
    Robert HintonAug 3, 2025
    What to do if my Aquallice ASPIRE 75 releases only a small flow of water?
    • M
      Martin GrayAug 3, 2025
      If your Aquallice Swimming Pool Pump releases only a small flow of water, several factors could be responsible. First, examine the filter cap; a bad seal can restrict water flow, so clean the cap and check the rubber seal. A blocked pre-filter can also reduce flow, so ensure you clean the filter regularly. Load loss in the installation can impede water flow, so prevent parts from causing load loss wherever possible. Finally, ensure the pump is correctly secured.
  • J
    Jamie LangAug 18, 2025
    Why did my Aquallice ASPIRE 75 motor stop?
    • J
      Jennifer EstesAug 18, 2025
      If your Aquallice Swimming Pool Pump motor has stopped, there are several potential causes. An increased temperature in the terminal box due to an electric arc could be the reason; in this case, check the terminal box connections. Also, the thermal protection might be tripping. If this is the case, connect the cables correctly to the terminal boxes. Incorrect terminal box connections can also stop the motor. To resolve this, tighten the cable correctly to the terminal and adapt the size of the cable connection to the terminal box. If the motor is blocked, remove the motor and contact the technical service.

Summary

General Safety Instructions

Safety Symbols and Warnings

Explains safety symbols and the risks associated with ignoring instructions.

General Safety Regulations

Pump Purpose and Operating Conditions

Pump designed for pool pre-filtering and recirculation with clean water up to 35°C.

Installation and Assembly Warnings

Electrical Wiring and Grounding Precautions

Connect motor wiring per diagram, use AC supply with earth and RCD (30mA).

Operational and Maintenance Safety

Do not use pool while pump runs, avoid contact with moving parts, disconnect power for maintenance.

Installation and Assembly General

Compliance and Mounting Requirements

Install in compliant pools, pumps have mounting feet for anchoring.

Location and Ventilation Guidance

Fit below water level; if above, limit suction head to 0.02 MPa and shorten pipe.

Electrical Installation

Disconnection and Protection Measures

Use disconnection device with 3mm gap, connect to AC supply with RCD (30mA).

Motor and Wiring Checks

Adjust thermal relay, check earthing cable, respect connection conditions, use skilled personnel for mains connection.

Start-Up Instructions

Prior to Start-Up Procedures

Remove pre-filter cap, fill pump with water, check mains voltage/frequency, fit cap securely.

Start-Up Steps

Open all valves and connect the motor.

Maintenance

Routine Cleaning and Checks

Clean pre-filter basket, check motor current, empty pump in cold weather, clean seals.

Component Replacement Guidance

Pump components wear out; table lists perishables like O-rings, seals, bearings with 1-year life.

Troubleshooting

Common Pump Issues and Solutions

Lists issues like not primed, low flow, noise, not starting, and their corresponding causes/solutions.

Spare Parts

Parts List and Identification

Detailed list of pump components with descriptions, quantities, and part numbers.

Evidence of Conformity

Compliance Declarations and Directives

Declares compliance with Machine, EMC, Low Voltage, and Noise Directives, and EN standard.

Aquallice ASPIRE 75 Specifications

General IconGeneral
BrandAquallice
ModelASPIRE 75
CategorySwimming Pool Pump
LanguageEnglish