EasyManua.ls Logo

AquaLogic DC-DSHP - User Manual

AquaLogic DC-DSHP
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Visit our website to see more of our products.
www.AquaLogicInc.com
Aqua Logic, Inc.
9558 Camino Ruiz.
San Diego, CA. 92126
PH: 858.292.4773
email: info@aqualogicinc.com
www.AquaLogicInc.com
© 2017 Aqua Logic, Inc. Rev 1
DC SERIES DUAL STAGE DIGITAL TEMPERATURE
CONTROL INSTRUCTION MANUAL FOR ALL DSHP
HEAT PUMPS
Model No. DC-DSHP
Thank you for purchasing our
digital temperature controller. It is
designed to provide on/off control for commercial heating and cooling
applications. It is equipped with a red LED
display that provides a
constant readout of the water temperature, and a touch keypad that
allows the user to easily and accurately select
the setpoint
temperature, differential and heating / cooling
modes of operation.
The control enclosure has an NEMA 4X rating but, if installed
outdoors, it should be protected against the direct weather.
Installation.
1. Mount control on a wall or any vertical surface that water
can’t splash on it.
2. Install the titanium temperature sensor in your tank or sump.
Careful not to submerse beyond the warning label.
Note
: For your safety, you must plug the HEAT PUMP into a dedicated 15 or
20 Amp. GFIC (Ground Fault
Interruption Circuit) circuit. When installing the
control
in a wet area make sure to have the power cords with drip loops so
water does not collect around the electrical connections.
Inline Titanium heaters
1 kW thru 60 kW
Safety water flow
cutout switches
1” thru 3” pipe
TLC Trimline Cyclone Drop-
in coil water chillers -1/4
and 1/3 HP
Delta-Star inline water
chillers. -1/4 thru 1-1/2 HP
Question and Answer IconNeed help?

Do you have a question about the AquaLogic DC-DSHP and is the answer not in the manual?

AquaLogic DC-DSHP Specifications

General IconGeneral
BrandAquaLogic
ModelDC-DSHP
CategoryTemperature Controller
LanguageEnglish