Why does my Aquapick Personal Care Product only work for a few minutes after charging?
If your Aquapick Personal Care Product only works for a few minutes even after a full charge, it could be due to two reasons: either the battery has reached the end of its life cycle, or the charging time was insufficient. Ensure you charge the unit for about 24 hours. If the problem persists, the battery may need replacing.
What to do if water does not come out of my Aquapick Personal Care Product?
If water isn't coming out of your Aquapick Personal Care Product, there are a couple of things to check. First, make sure the tank is filled. If the tank isn't empty, ensure you're using the product in a vertical position, as tilting it too much can prevent water flow.
How to increase water pressure on my Aquapick Personal Care Products?
If the water pressure is very low on your Aquapick Personal Care Product, the issue might be due to a blockage or a deformed jet tip. Here's what you can do: * Replace the jet tip if there is dirt stuck in it. * Clean the filter if there is dirt stuck in it; you can also purchase a replacement filter.
General| Model | AQ-230 |
|---|---|
| Battery Type | Lithium-Ion |
| Power Source | Rechargeable Battery |
| Charging Time | 4 hours |
| Waterproof | IPX7 |
| Product Type | Oral Irrigator |
| Type | Cordless |
| Pulse Rate | 1400 pulses/min |
| Pressure Range | 100 psi |
| Operating Modes | Normal, Soft, Pulse |
| Usage Time | Up to 14 days on a single charge |
To Next Page