What to do if my AquaPRO Water Dispenser display is flashing?
If your AquaPRO Water Dispenser display is flashing or blinking, it usually means a power outage has occurred. You can either wait 5 minutes for the blinking to stop, or press any key on the keypad to resolve the issue.
What to do if my AquaPRO WaterPro displays “ERROR CODE SERVI UNI CE T”?
If your AquaPRO Water Dispenser displays the error code “ERROR CODE SERVI UNI CE T”, perform a Master Reset by holding the Shift button and cycling power. Also, go through all screens in Master Programming Mode. You can also manually initiate a regeneration cycle by pressing the Extra Cycle button for 5 seconds.
What to do if my AquaPRO WaterPro Water Dispenser displays “ERROR CODE UNI PROGRAM T”?
If your AquaPRO Water Dispenser displays the error code “ERROR CODE UNI PROGRAM T”, go through all screens in Master Programming Mode.
What to do if my AquaPRO WaterPro unit is not responding after going into regeneration?
If your AquaPRO Water Dispenser unit is not responding after going into regeneration, verify the unit is configured correctly (for example, wiring valve type). Perform a Master Reset by holding the Shift button and cycling power. Check and verify the choices selected in Master Programming Mode.
Details on how time-clock and meter-initiated valves trigger regeneration.
Procedure to manually start the regeneration cycle using the Extra Cycle button.
Methods to access the Master Programming Mode.
Procedures for exiting the programming mode with or without saving.
Selects the operational mode of the water softener system (e.g., Time Clock Delayed).
Specifies the model of the control valve being used (e.g., 56XT/6700).
Sets how the regenerant flows through the resin tank, matching the valve cam.
Sets the total capacity for hardness removal in the selected units.
Input for feed water hardness, used for automatic volume calculations.
Sets a percentage to reduce the unit's reserve capacity.
Configures the volume override function for regeneration triggering.
Programs the duration for each of the five regeneration cycle steps.
Lists specific error codes displayed by the timer and their corrections.
General| Brand | AquaPRO |
|---|---|
| Model | WaterPro |
| Category | Water Dispenser |
| Language | English |
To Next Page