AQUARAY Control User Manual

Maintenance
Caution: To avoid possible electric shock, special
care should be taken when using this appliance
near water.
Caution: Always isolate the PSU from the mains
electricity before carrying out any maintenance on
your AquaRay set up.
The AquaRay Control unit is not a customer
serviceable part.
Caution: Do not attempt to open the plastic
case of the AquaRay Control unit. This will
invalidate the guarantee.
The AquaRay Control unit should need little or
no maintenance once set up. However occasional
cleaning may be necessary. This can be done with
a warm damp cloth.
Troubleshooting
Problem: The AquaRay Control Unit does not
switch on.
Solution: Check cable connection between PSU and
control
Solution: Check power cord is firmly connected to PSU.
Solution: Check (and replace if necessary) the
fuse in the PSU’s power cord plug (UK only).
If the control still does not switch on, return the
unit to your local stockist for further testing and
replacement if necessary.
Problem: The AquaRay Control Unit does
not control the lamp units.
Solution: Check the connection between the
lamp units and the AquaRay Control unit.
Solution: Check the program settings.
If the control still does not control the lamp
units, return the unit to your local stockist for
further testing and replacement if necessary.
6

AQUARAY Control Specifications

General

Brand	AQUARAY
Model	Control
Category	Controller
Language	English