Operating Instructions
Important Safety Information –
Please read carefully
Input: 24V DC 5A
Output: 8 x 15.5-19.5V DC 0.7A (0-100% PWM)
Caution: Do not use any power supply other than the
one supplied with your genuine AquaRay SmartControl 8
unit. The use of a different power supply will invalidate the
guarantee.
- Always isolate the PSU from the mains electricity
before installing or carrying out any maintenance
to your AquaRay SmartControl 8 unit unit.
Caution: The AquaRay SmartControl 8 unit is not
waterproof and therefore must not be mounted above the
aquarium or in any position where it may accidentally fall into
water or be splashed by water.
Caution: Do not operate this appliance if it has been
damaged, is malfunctioning, or has been dropped or
immersed in water.
- This unit is designed to be used indoors and is
not suitable for any outdoor applications.
Caution: Always leave a drip-loop in the DC supply cable
to the AquaRay lamp unit to prevent water
running down the cable and reaching the AquaRay
SmartControl 8 unit.
- Dispose of this unit responsibly. Check with
your local authority for disposal information.
1
s
To Next Page
Loading...
