Name: AquaScape IonGen
Brand: AquaScape
Rating: 5 (1 reviews)

Questions and Answers:

Alan SmithJul 27, 2025

What to do if AquaScape Water System has cloudy water?

J
janemartinJul 27, 2025
If your AquaScape Water System has cloudy water, it could be due to several reasons. The copper level might be too low, so try raising the ionization level. There might be insufficient flow through the Flow Chamber; in this case, increase pump run time or move the Flow Chamber to a higher flow location. Check also for debris stuck on the Probe, and if found, remove the Probe and clean any debris or scale build-up off the bars. It may also be that the water parameters are not correct, so check the Targeted Water Parameters table.

Jessica MunozJul 31, 2025

Why is the copper level low in my AquaScape IonGen Water System?

A
andreabrownJul 31, 2025
A low copper level in your AquaScape Water System can occur for a few reasons. The ionizing level may be set too low, so try raising it. Insufficient flow through the Flow Chamber can also cause this; increase the pump run time or move the Flow Chamber to a higher flow location. Additionally, the Probe might be exhausted; inspect it and replace it if necessary.

Brand

Model

IonGen

AquaScape IonGen Faq

Other manuals for AquaScape IonGen