ASSEMBLY INSTRUCTIONS
6
7. The installation is completed. Now remove the
sprayer from the spray hose by unscrewing it in
a counterclockwise direction and turn the water
for at least one minute for each hot and cold.
Check for leaks. Re-tighten any connections if
necessary, but do not overtighten. Reinstall
sprayer head by hand tightening it back onto the
spray hose. Do not let go of the hose until you
have reattached the sprayer.
7
6. To install soap dispenser, insert body assembly
(N) through selected hole of sink. Secure body
assembly (N) to sink with mounting nut (O).
From under the sink screw the bottle (P) onto
the shank of body assembly (N). Insert pump (Q)
down into the body assembly (N).
N
O
P
Q
6
To Next Page
Loading...
