1
HIGH-EFFICIENCY DUAL-FLUSH TOILET
ITEM #0274044
MODEL #T801
Español p. 13
Français p. 7
ARE YOU READY?
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING: Do not use in-tank cleaners in your toilet.
Products containing chlorine (calcium hypochlorite) can
seriously damage ttings in the tank. This damage can cause
leakage and property damage.
CAUTION: Do not lift or rock the bowl after placement. If
you break watertight seal, you must install a new wax seal.
Be sure the water supply valve is shut o before installation.
If replacing an existing toilet, follow these general guidelines. (Not all
toilets and connections are the same. Therefore, these guidelines may
or may not apply.)
Remove Old Toilet
1. Turn o water supply and ush tank completely. Use a towel to
dry remaining water from tank and bowl.
2. Disconnect and remove old water supply line.
3. Remove tank from bowl by removing old tank-to-bowl hardware.
4. Remove bowl from oor by removing bolt caps and oor bolt nuts.
5. Remove oor bolts from toilet ange and clean old wax, putty and
sealant from base area. (Temporarily plug oor ange with a towel
or cover to block sewer gases from escaping.)
NOTE: Mounting surface must be clean and level before
new toilet is installed.
Estimated Installation: 50 Minutes
Questions, problems, missing parts? Before returning to your retailer, call our customer service
department at 1-866-417-7564, 8 a.m. - 8 p.m., EST, Monday - Friday.
AquaSource
®
is a registered trademark of LF, LLC.
All Rights Reserved.
DO YOU HAVE?
Putty Knife
Flathead
Screwdriver
Carpenter’s
Level
Safety
Goggles
Adjustable
Wrench
Supply Line
Hacksaw
NOTE: Items not included.
ATTACH YOUR RECEIPT HERE
AB16338
To Next Page
Need help?
General