Aquatec ERP 500 User Manual

Inspect the Permeate Pump, optional items, and remove plugs from ports for foreign material.

Firmly attach John Guest stem fittings to the John Guest ports, ensuring each stem bottoms out.

Mount the Permeate Pump using a clip kit or a retrofit kit, attaching it to the R.O. membrane housing.

Mount the Permeate Pump with both brine and permeate outlets positioned UP to remove entrapped air.

Shut off feed water, close product tank valve, and bleed residual pressure by opening the faucet.

Connect the 'BRINE TO DRAIN' tube, ensuring the flow restrictor is before the 'brine inlet'.

Connect the product water tube to the 'PERMEATE IN' fitting and from 'PERMEATE OUT' to the hydraulic shut-off valve.

Turn on feed water, open tank valve, and verify pump cycles audibly; check connections if not cycling.

Identifies the Permeate Pump model (ERP 500 or ERP 1000) for system capacity.

Describes the pump mechanism as positive displacement, reciprocating, single action diaphragm, hydraulically driven.

Specifies the weight of the Permeate Pump, which is 1 lb.

Lists wetted materials as NSF listed and/or FDA approved for potable water contact.

Details fittings used, including John Guest quick disconnect ports and optional elbow fittings.

Instructs to always mount with outlet ports up and use the provided mounting clip assembly.

Explains ordering a membrane clip for retrofit mounting to the membrane housing clip.

Specifies maximum operating pressure for brine and permeate sides as 100 PSI.

Defines operating environmental parameters for humidity and temperature for ambient and water.