The remote has a built-in Polymer Lithium rechargeable battery and comes with a charging cable.
Connect one end of the charging cable to the charging connection on the remote control and con-
nect the USB end of the charging cable to any USB charger (5V DC) for charging.
Make sure the remote has been charged before used.
1.8 Handheld Remote Control Charging
If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote
control if the battery is low.
Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD
shows nothing, the battery has been drained and will need charging.
If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the
new remote control.
1.9 Handheld Remote Control Synchronizing
1. Make sure SWA6+ is powered ON (green LED)
2. Put the remote within 0.5 meter of the SWA6+.
3. Press and hold MODE on remote control until the LCD shows “Pairing in Progress”.
Release the button.
4. Within 2 seconds, the LCD will show “Paired”. If it fails to pair, the LCD will show
“Pairing Failed”. If this happens, wait 5 seconds and repeat steps above.
The remote should already be paired from the factory, but if you need to synchronize the remote,
follow the steps below.
For any additional remote controls, you will also need to synchronize those remote controls to the
SWA6+.
Getting Started Combined Stereo Subwoofer SWA6+
8www.aquaticav.com
To Next Page
Loading...