To Next PageTo Next Page
Need help?Do you have a question about the AquaticLife Deionized Spot-Free Car Rinse Plus and is the answer not in the manual?
General| Brand | AquaticLife |
|---|---|
| Model | Deionized Spot-Free Car Rinse Plus |
| Category | Water Filtration Systems |
| Language | English |
Use tap water for initial vehicle wetting and rinsing to conserve DI cartridges.
Spray vehicle with fine mist of DI Spot-Free Rinse water for a spot-free finish.
Avoid using spot-free rinse for initial steps to prevent rapid cartridge depletion.
Explains how TDS in water causes spots on vehicles when evaporated.
Details how resin absorbs TDS and changes color, indicating replacement need.
The unit requires incoming water pressure to be 80 PSI or less; a regulator may be needed.
Deionized water can leach copper from pipes, potentially causing damage.
DO NOT pressurize and operate the unit unattended.
Apply pipe tape to fittings and use washers for leak-free connection.
Mount securely to a surface, avoiding direct sunlight, using appropriate screws.
Connect hoses to the unit's supply and filter sides, attach nozzle with washer.
Center resin cartridges in canisters and hand-tighten, then use wrench for final seal.
Replace cartridges when color changes; move used cartridge to first position.
Keep resin wet; avoid freezing or temperatures above 100°F; never store in direct sunlight.
Verify fittings, tape, washers, and o-rings for proper seal and initial operation.
Avoid direct sunlight, temperatures above 100°F, and freezing conditions.
Rotate canister head assembly 180 degrees to alter water supply and filtered flow.
Higher incoming TDS depletes resin faster; replace when color changes.
Covers defective components and leaks for one year, excluding cartridges.
Excludes damage from accident, misuse, abuse, or failure to follow instructions.
Disclaims implied warranties and consequential damages; state laws may apply.
Notify Lifetime Products in writing of defects within 30 days; use provided contact info.
