Aquavista 500R User Manual (English)

To Next Page

Aquavista 500R Water Pump

Test Instructions

WARNING!!! ALWAYS TURN OFF THE POWER AND UNPLUG

THE AQUARIUM BEFORE SERVICING

*Please read the instructions thoroughly before you begin servicing*

Tools Needed:

1. Middle size Philips head screwdriver

2. Small size Flat head screwdriver

Step 1

Make sure the power cord is unplugged and

the tank is off.

Now remove the frame from the aquarium as you

would do so normally.

Step 2

Locate the round blue sticker which can be found at

the top right hand corner of the tank.

Remove the screw that is located behind the round

blue sticker using a small size flathead screwdriver.

Need help?

Do you have a question about the Aquavista 500R and is the answer not in the manual?

Aquavista 500R Specifications

General

Lists the necessary Philips and flathead screwdrivers for servicing the water pump.

Ensure power is off and unplugged, then remove the aquarium frame.

Find the blue sticker and remove the screw hidden behind it.

Use a screwdriver to carefully remove the aquarium's side panel.

Disconnect two connectors from the LCD and keypad to the circuit board.

Replace the light connector with the water power wire.

Slide the LCD and keypad control panel back into place.

Plug in, reset clock, and press the light button to confirm pump is running.

Determine if the relay or the pump itself needs replacement based on test results.