Unit switch :
Sv (SI unit, default)
or rem
CAUTION
Switches can be found behind the batteries.
Use the attached pin to adjust these settings.
▪ Do not remove the sticker on the back of Aranet Radiation sensor.
▪ Aranet Radiation is not impact-resistant. Exposure to strong
accelerations can lead to erroneous device measurements.
▪ Do not expose Aranet Radiation to high-humidity environments.
▪ Exposing the sensor to X-ray scans, like those at airport baggage
controls, temporarily raises the dose rate reading and total dose
readings, which can be disregarded or mitigated by removing the
sensor batteries during scans.
Configuration switches
Sv
rem
OFF OFF
ON
Bluetooth:
On (default) or O
Pulse buzzer:
On (default) or O.
If turned on, it notifies
about pulses counted.
LoRa transmission
(non-functional for
HOME sensors):
On (default) or O.
For more technical information see
Aranet Radiation sensor data sheet.
See more
To Next Page
Loading...
Need help?
General
