ARB Jack - Page 7

JACK Instruction Manual / 7
Original Instruction
15. Do not lit any object or vehicle that is occupied.
All passengers/persons must vacate the object or vehicle prior to being lited.
16. Chock and Block (stabilise)
A chock is a wedge which is placed under the un-lited wheels to inhibit
the wheels from rolling.
When you block a load, you secure and support a load that has been lited.
Apply park brake in the vehicle before operating the Jack.
Chock the wheel opposite the end being lited.
With the vehicle lited, place the block or stabiliser under an appropriate
location on the vehicle.
The block or stabiliser must have a load rating greater than the load
being lited.
17. Additional Notes
Retain the original or a copy of the receipt, warranty and these instructions.
It is important that you read the entire manual to become familiar with your
Jack before use.
• DO NOT MODIFY the Jack in any way. Unauthorised modification may impair
the function, lifespan and/or safety of the Jack. The Jack was designed for
specific applications.
• ALWAYS CHECK FOR DAMAGED OR WORN out parts before using the Jack.
Broken parts will afect the equipment operation.
• When the Jack is not in use, the Jack must be stored in the bag provided.
Inspect for good working condition prior to storage and re-use.
• Keep away from children.
• Not tested for use in potentially explosive environments.
• Not tested for use in areas with potential for sensitivity to static electricity.
• Not intended for use in the liting of dangerous materials.
• Not intended for the use of contact and/or preparation of food.
• Not intended for use in marine environments and/or on maritime vessels.
• This product does not exceed 70dB(A) during operation. Hearing PPE not
required during operation.
The Jack was designed to reduce risks and increase safety. Operation of
the Jack may have the potential to cause harm if used improperly. Ensure all
instructions are read and understood prior to operation of the Jack.