Arbiter Systems 1040C Training Manual

Name: Arbiter Systems 1040C
Brand: Arbiter Systems
Rating: 4 (1 reviews)

20 pages

To Next Page

To Previous Page

DC Current Operating Procedure

CAUTION: Prior to making any connections, place the PMC in Standby Mode.

Connect the Model 918B to the PMC as shown below and perform the following steps:

1. Press DC.

2. Press CURRENT.

3. Enter the desired current using the keypad and the units key.

4. Press OPER.

5. MODIFY, MEMORY, or % DEV may be used.

6. To remove the output signal, press STBY when the measurement is complete.

Other manuals for Arbiter Systems 1040C

Need help?

Do you have a question about the Arbiter Systems 1040C and is the answer not in the manual?

General