Arc Machines 207A - Page 5

MODEL 207A AND 207A-1
OPERATION MANUAL
Doc. No. 740044
Rev F
TABLE OF CONTENTS
SECTION DESCRIPTION PAGE
SECTION V OPERATION
5.0 Introduction 5.1
5.1 Initial Power On 5.1
5.2 Use of Next/Prev 5.2
5.3 Weld Schedule Selection 5.4
5.4 Viewing Function Values 5.5
5.5 Overriding Function Values Before Seq 5.6
5.6 Overriding Function Values During Seq 5.7
5.7 Set Up Functions 5.7
5.8 Auto Rotation Calibration 5.11
5.9 Manual Rotation Calibration 5.13
5.10 Welding Operation 5.15
5.11 Printer Operation 5.16
SECTION VI PROGRAMMING
6.0 Introduction 6.1
6.1 Create A Weld Schedule 6.1
6.2 Modify A Weld Schedule 6.4
6.3 Copy a Weld Schedule 6.5
6.4 Transfer/Receive A Weld Schedule 6.6
6.5 Delete A Weld Schedule 6.7
SECTION VII CALIBRATION
7.0 Introduction 7.1
7.1 Equipment Required 7.1
7.2 Current Servo 7.2
7.3 General Maintenance 7.5
7.4 System Fault Corrections 7.6
7.5 Error Messages 7.9
7.6 Miscellaneous Maintenance Items 7.10
SECTION VIII OPTIONS
8.0 Introduction 8.1
8.1 M227/207-CW & M207-CW Cooling Unit 8.1
8.2 M-207-RP Remote Pendant 8.3
8.3 M-207-EMM External Memory Module 8.7
iv