remote
control
Inserting batteries into the
remote control
1. Open the battery compartment by pressing
the button on the back of the handset.
2. Insert four ‘AAA’ batteries into the battery
compartment – two facing the top of the unit,
and two facing the end, as in the diagram.
3. Lower the end cap onto the plastic locating
plate in the handset. is acts as a hinge, and
you can now push the end cap rmly into its
locked position with a click.
The CR90 Universal remote
controller
e CR90 is a sophisticated ‘universal’ remote control
that can control up to eight devices – including the
CD37. As it’s a ‘learning’ remote, it can copy almost
any function from an existing single-device remote.
You can also program the CR90 to issue a sequence of
commands (‘macros’) from a single button press – see
the CR90 Handbook for details.
Select the source key rst
Remember to select a source key before pressing
command buttons – commands vary depending on the
source selected.
To operate the CD37 from the remote, rst press the
CD
source button.
To Next Page
Loading...
