Need help?Do you have a question about the Arcam Delta 290 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Power Output | 75W per channel into 8Ω |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion | 0.02% |
| Signal to Noise Ratio | >100dB |
| Input Sensitivity | 150mV (line) |
| Damping Factor | >100 |
| Dimensions | 430 x 100 x 360 mm |
Describes the selection of 6 line level inputs using a motorised listen switch.
Details the tone control stage, balance control, and preamp out buffer.
Explains the signal path into the power amp stage and its output stage components.
Outlines the toroidal transformer and its secondary windings for power supply generation.
Details the functions of IC501 for turn on delay, DC offset, and thermal cutout.
Describes the optional phono stage for MC/MM cartridges and RIAA equalization.
Diagram illustrating input selection circuitry and connections.
Diagram for the remote control receiver and associated circuitry.
Circuit diagram detailing tone controls and preamp output stages.
Circuit diagram for the power amplifier stage, specifically for Issue 7 PCBs.
Diagram showing protection circuits and mains input connections.
Circuit diagram for the optional MM/MC phono amplifier stage.
Circuit diagram for the power amplifier stage for PCBs prior to Issue 7.
To Next Page
