Need help?Do you have a question about the Arcam Delta 90 and is the answer not in the manual?
General| Power Output | 50W per channel into 8Ω |
|---|---|
| Total Harmonic Distortion (THD) | 0.02% |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | 100dB |
| Input Sensitivity | 150mV |
| Weight | 6.5 kg |
| Output | Preamp Output |
Describes the input stage for MM/MC cartridges and RIAA equalization, including RF interference rejection.
Explains signal selection for amplification and routing to tape outputs, including CD input attenuation.
Details the line amplifier stage providing 18dB gain and volume control with transistor stages.
Describes the bass/treble tone control circuit and the function of the direct switch.
Details the single-transistor input stage, class AB operation, and output stage current handling.
Covers protection stages for overcurrent/overvoltage and stability measures against oscillations.
Explains the DC servo IC for maintaining low DC offset on the loudspeaker output.
Describes the amplifier output relay functions for on/off mute and DC offset speaker protection.
Details the ±15V regulator circuits providing power to preamplifier stages and DC servos.
Provides guidance on replacing components, emphasizing matched pairs for transistors.
Crucial safety warning regarding the replacement of the mains fuse with the correct rating and type.
To Next Page
