ARCAM ST25 OM EN V1
9
The Control connection allows for the ARCAM ST25 to synchronise with, and control an ARCAM Radia series
amplifi er (not SA35 or SA45). When streaming, it allows for the combination of streamer and amplifi er to act as
one.
Complete the following steps to enable this feature:
1. Ensure power is disconnected from the Streamer and Amplifi er.
2. Connect either an analogue or digital audio connection from the output of the ST25 to an input of the
ARCAM amplifi er.
100-120V/220-240V ~ 50/60Hz
15W MAX
POWER INLET
COAX
OUT
OPTICAL
OUT
TRIGGER
OUT
NETWORK
CONTROL
USB
3. Connect the control cable from the ST25 CONTROL socket to the CONTROL socket on the ARCAM
amplifi er.
4. Power on both ST25 and ARCAM amplifi er.
5. In the ST25 settings menu, set the Volume Mode option to EXTERNAL.
6. In the ST25 settings menu, set the Output Type to Analogue or Digital to match the audio connection type
used.
7. In the ARCAM amplifi er, set the Streamer Input option in the System Settings menu to match the input that
you have connected the ST25 into.
Top Tips
¢ When the Volume Mode is set to Variable or External, there is a Maxmium External Volume to prevent
accidental excessive volume jumps. The default is 40. This value can be changed in the menu of the ST25.
C O N T R O L S E T U P
To Next Page
Loading...