STARTING AND OPERATING
Starting
1. Turn the ignition key to the extreme right.
Release the key as soon as the engine
starts.
Do not turn the starting motor for
more than 10 seconds at any time. It
is not good for starter motor to run
for long time.
2. Never race the engine during this warm-
ing-up period.
Stopping
To stop the engine, idle the engine, turn the
ignition key to the “OFF” position, then the
engine will stop.
Except in an emergency, be sure to
turn the ignition key off only after the
engine speed has returned to idle.
CCAUTIONS DURING OPERATION
During engine operation, the warning light
should remain OFF. If it comes ON immedi-
ately stop operation, and take the actions that
are described below.
If any other abnormalities such as unusual
noise vibration or shocks are observed again,
stop the operation, and make the necessary
inspection and repair.
At completion of the day’s opera-
tions
1. Make sure that there is no oil leak, water
leak, or any other defects.
2. Clean the exterior of the engine so that
any oil leak, water leak, fuel leak or other
defect may be easily detected.
3. If antifreeze is not used in the cooling sys-
tem in cold weather, be sure to discharge
the cooling water to prevent damage to
the engine and/or radiator due to freez-
ing water.
4. Repair any faulty parts detected during
operation.
4
To Next Page
Loading...