To Next PageTo Next Page
Need help?Do you have a question about the Arconic Huck Powerig 940 and is the answer not in the manual?
General| Brand | Arconic |
|---|---|
| Model | Huck Powerig 940 |
| Category | Portable Generator |
| Language | English |
Introduction of foreign material into Hydraulic Unit will result in poor performance and down time for repair.
Fill the reservoir with hydraulic fluid, approximately 2.6 gallons (9.8 liters), until the fluid level is between the grooves of the dipstick.
Check PULL and RETURN pressures before use, before troubleshooting, and after overhauling.
Adjusts the maximum PULL pressure by loosening a jam nut and turning an adjusting screw.
Adjusts the RETURN pressure by loosening a jam nut on the pressure switch and turning an adjusting screw.
Check fluid level, inspect hoses, check system, and check electrical cord before operating.
Plug control cable, let unit operate, attach nose assembly, and plug power cord into outlet.
Scheduled inspections to detect and correct minor troubles, including hose checks, fluid levels, and motor brushes.
Instructions for returning the unit for pump overhaul or completing the unit at a repair facility.
Procedure for replacing the coupling between the motor and the pump assembly.
Detailed steps for adjusting the pressure switch using shims and an adjustment screw.
Steps to check motor brushes, clean commutators, and replace brushes if worn.
Warranty for BobTail® installation tools manufactured after 12/1/2016 for their useful lifetime.
Warranty for installation tools and Powerigs® manufactured after 12/1/2016 for a period of two years.
Warranty for nose assemblies and accessories for a period of 90 days from date of purchase.
Disclaimer regarding warranties for third-party manufactured tooling, parts, or other items.
Information about Huck International's right to change specifications and recommendations for servicing.
