Need help?Do you have a question about the Arctic Cat 2015 XF 6000 and is the answer not in the manual?
General| Brand | Arctic Cat |
|---|---|
| Model | 2015 XF 6000 |
| Category | Snowmobiles |
| Language | English |
Details warranty durations for recreational and commercial use, and for batteries.
Lists parts and conditions excluded from warranty coverage.
Lists actions or conditions that will void the warranty.
Exclusion of implied warranties of merchantability and fitness for purpose.
Section for recording snowmobile details and dealer information.
Safety advice to avoid injury, emphasizing reading manual and common sense.
Introduces the manual, explains safety symbols, and notes on product updates.
States conformity to European directives and lists model numbers.
Visual guide to 12 key safety rules for snowmobile operation.
Explains the importance of Vehicle Identification Number and Engine Serial Number.
Identifies typical control locations on the handlebars for different models.
Specifies correct gasoline and injection oil types, and filling precautions.
Provides instructions and warnings for filling the gas tank safely.
Details break-in requirements for 6000 and 8000 series engines.
Explains the necessary break-in period for new drive belts.
Describes the standard gauge layout and indicator icons (A-F).
Explains navigation and resetting of odometer, trip meters, and hour meter.
Detailed steps for setting the clock on electric start models.
Explains how to display and switch between RPM and MPH/kph.
Explains the function and troubleshooting of the service icon on electric start models.
Describes the coolant temperature warning icon and its behavior.
Explains the low oil warning icon and recommended checks.
Describes the deluxe gauge layout and its indicator icons (A-H).
Covers altimeter settings and clock setting procedures.
Reiterates information on Service icon and Coolant Temperature Warning.
Further details on Coolant Temp and Low Oil warning indicators.
Explains specific indicators within the Deluxe Digital Gauge (A-D).
Describes displays for temp, voltage, fuel level, RPM, and altimeter.
Explains diagnostic code activation and what to do if a code appears.
Lists diagnostic trouble codes and their descriptions for the 6000 series.
Lists diagnostic trouble codes and their descriptions for the 8000 series.
Provides steps for adjusting the handlebar tilt on ZR/XF models.
Details how to adjust handlebar height and tilt on M models.
Explains how to adjust the angle of the speedometer/tachometer.
Information on the Exhaust System and Air-Intake Silencer.
Instructions for inspecting and maintaining the closed liquid cooling system.
Covers battery maintenance and safe jump-starting procedures.
Explains cleaning requirements and dealer service for drive clutches.
Discusses alignment checks and when dealer service is needed.
Maintenance for fuel pump and rebuildable gas shock absorbers.
Information on track wear, types, and track stud installation warnings.
Specifics on the Power Claw track and its wear characteristics.
Warnings about operating with track studs and ensuring proper installation.
Explains how to use the reverse function and shift procedures.
Details engagement, operation, and cancellation of the reverse function.
Step-by-step guide for removing and installing the access panel and hood.
Instructions for removing and installing removable seats.
Specific caution for LXR models regarding the seat heater harness.
Specific instructions for removing the seat on M models.
Guidance on towing and introduction to the Arctic Power Valve system.
Describes the ECT system and its role in ignition timing.
Comprehensive guide to starting and stopping the engine safely.
Importance of proper warm-up before operating and consequences of insufficient warm-up.
Explains how brakes work and the effects of heat on brake fluid.
Details care for brake fluid, including level checks and contamination warnings.
Lists various methods for stopping the snowmobile in emergencies.
Explains the function of the throttle monitor switch and troubleshooting.
What to do if the throttle control lever or monitor switch malfunctions.
How altitude affects performance and necessary adjustments.
Procedure for checking and adding lubricant to the chain case.
Steps for draining and replacing chain case lubricant.
Instructions for lubricating rear suspension grease fittings.
A comprehensive checklist of maintenance items with intervals and remarks.
Warnings regarding fuel leaks and working near open flames or sparks.
Instructions for replacing the in-line fuel filter on 6000 models.
Information on additives and suspected fuel flow issues.
How to check and add engine oil for different models.
Instructions for checking and adding coolant to the engine.
Guidance on using correct spark plugs and interpreting their condition.
Step-by-step instructions for removing and installing spark plugs.
Procedure for checking and adjusting the APV system cables.
Steps for removing, cleaning, and charging sealed batteries.
Chart detailing battery voltage, charge state, and charging times.
Procedure for reinstalling the battery and connecting cables.
Explains fuse function, location, and replacement procedures.
Daily checks for the brake system components and operation.
How to check, add, and change brake fluid.
Procedure for checking brake lever travel before each use.
Steps to bleed the brake system to remove air bubbles.
How to check brake pad condition and when to replace them.
Procedure to burnish new brake pads for optimal effectiveness.
How to inspect the drive belt and check its deflection.
Steps for removing and installing the drive belt.
How to adjust drive belt deflection using shim washers.
Explains why proper track tension is crucial and how to check it.
Steps for adjusting track tension on both sides of the snowmobile.
Explains the importance of track alignment and how to check it.
Detailed steps for adjusting track alignment.
Adjusting front arm shock spring tension and limiter straps.
How to adjust the front shock springs for ski pressure.
Information on adjusting air pressure in Sno Pro model air shocks.
Chart for setting rear shock pressures based on weight and riding conditions.
Adjusting front arm shock spring tension and limiter straps.
How to set rear spring pre-load using cam positions based on rider weight.
Adjusting rear arm shock spring pre-load for M/XF models.
Instructions for replacing the LED taillight/brakelight.
Procedure for adjusting the vertical aim of the headlight beam.
Purpose, wear, and replacement of ski wear bars.
Steps for installing new ski wear bars.
How to adjust the ski stance and related warnings.
Checking and replacing rail wear strips.
Procedure for tempering new rail wear strips.
Importance of the drive belt and its proper fit and condition.
How to check and adjust drive belt deflection for optimal performance.
Procedures for cleaning and checking the offset of drive/driven clutches.
Detailed steps for preparing the snowmobile for storage.
Tips for storing the snowmobile indoors or outdoors safely.
Steps to take when removing the snowmobile from storage.
Statement regarding U.S. EPA emission control compliance and warranty.
Details the emission warranty period and covered components.
Owner's responsibility for proper maintenance according to the manual.
Procedures for updating address, ownership, or transferring warranty.
Outlines the warranty process, dealer responsibilities, and owner obligations.
To Next Page
