WARNING:
To reduce the risk of injury, user must read
and understand the operator’s manual for
their product and this instruction sheet.
Ensure compatibility and fit before using
this accessory. Do not use this accessory
if a part is damaged or missing. If you are
not comfortable performing any of the
functions described in these instructions,
call the customer service number for
assistance.
PACKING LIST:
Replacement Filter Media
Operator’s Manual
The following instructions apply only to
the EVC500 or EVC700 Evaporative Cooler.
INSTALLING NEW FILTER MEDIA
See Figures 1 and 2.
WARNING:
Always turn off the evaporative cooler
and disconnect it from the power supply
before replacing the filter media to avoid
possible serious personal injury.
Press inward on tabs to unlock the filter
media door.
Lower the filter media door and remove
the filter media.
Install the new filter media. Make sure the
filter media is seated properly inside the
filter media door.
NOTE: Be sure to orient the filter media
as illustrated.
NOTICE:
Do not operate the evaporative cooler
without the filter media while the pump
is running. Doing so could damage the
motor and reduce performance.
To secure the filter media door, insert the
tabs into the notch. Close the filter media
door and push the tabs until they snap into
place.
Fig. 2
Fig. 1
A - Filter media
B - Tabs
C - Filter media door
D - This end up
A - Tabs
B - Filter media door
C - Press inward on tabs to unlock
SAVE THESE INSTRUCTIONS
REPLACEMENT FILTER MEDIA
MAC750
POWER
FAN
SWING
TIMER
COOL
C
B
A
D
POWER
FAN
SWING
TIMER
COOL
A
B
C
C
For use with EVC500 or EVC700
To register your ARCTIC COVE product,
please visit www.arcticcove.com.
ONE WORLD TECHNOLOGIES, INC.
1428 Pearman Dairy Road / Anderson, SC 29625
Phone 1-877-297-8911 / www.arcticcove.com
991000130
2-13-18 (REV:02)
To Next Page
Need help?
General
