Page 10
Removing Collected Water
There are two ways to remove collected water:
1. Use the bucket
• When the unit is off, if the bucket is full, the unit will
beep 8 times and the Full indicator light will flash,
the digital display shows P2.
• When the unit is on, if the bucket is full, the
compressor turns off and the fan turns off after 30
seconds for drying the water of the condenser, then
the unit will beep 8 times and the Full indicator light
will flash, the digital display shows P2.
• Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the
as because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water
to spill.
• Throw away the water and reposition the bucket.
The bucket must be in right place and securely
seated for the dehumidifier to operate.
• The machine will re-start when the bucket is
restored in its correct position The unit will restart
operation when the bucket back in place.
NOTES
• When you remove the bucket, do not touch any
parts inside the unit. Doing so may damage the
product.
• Be sure to push the bucket gently all the way into
the unit. Banging the bucket against anything or
failing to push it in securely may cause the unit
not to operate.
• When you remove the bucket,if there is some
water in the unit you must dry it.
Operating
Instructions
Fig. 3
1. Pull out the bucket.
2. Hold both sides of the
bucket evenly, and pull
it out from the unit.
Fig. 4
3. Pour the water out.
To Next Page
Loading...