11
11
WARNING: Fill the spa with water before turning on the power.
Once your spa has been filled with water, turn it on and test all of the circuit breakers.
NOTE: If the GFCI breaker trips immediately, verify that the WHITE neutral wire is connected
into the load neutral in the breaker. Each breaker should be tested prior to each use. Here’s how:
1. Push the “TEST” button on each GFCI breaker, and observe it click OFF.
2. Push the breaker switch to the OFF position (to ensure that it has completely disengaged),
then push the breaker switch to the ON position.
If any of the GFCI breakers fails to operate in this manner, your spa may have an electrical
malfunction, and you may be at risk of electrical shock. Turn off all circuits and do not use the
spa until the problem has been corrected by an authorized service agent.
WARNING: Removing or bypassing any GFCI breaker will result in an unsafe spa and will void
the spa’s warranty.
IMPORTANT: Should you ever find the need to move or relocate your Arctic Spa
®
, it is
essential that you understand and apply these installation requirements. Your Arctic Spa
®
has
been carefully engineered to provide maximum safety against electric shock. Remember,
connecting the spa to an improperly wired circuit will negate many of its safety features.
To Next Page
Loading...
