Arctic Custom Series - Filling Your New Arctic Spa; Preparing the ORP Probe (SpaBoy Option)

Step 1: Filling your new Arctic Spa
1. Fill your spa with a garden hose put the hose in your filter canister. (img 1.1)
2. Once the water level has reached the bottom of the headrest, turn off the water and
remove the hose from the spa.(img 1.2)
1. Locate & remove the bottle protecting the end of the SpaBoy® probe. Remove by
gently pulling the bottle straight away from the wall. (img 2.1).
2. Insert the threaded safety grate provided by turning clockwise until snug (img 2.2).
Step 2: Preparing ORP Probe. ** SpaBoy® option only
Start by verifying if the SpaBoy® probe has been installed. Depending on
the time of year (freezing temps) and time between installation and hook
up the probe may not have been installed.
WARNING- Failure to remove the bottle or plug can result in over sanitization
damaging the spa, creating unsafe water and voiding warranty.
(img 1.1)
(img 1.2)
(img 2.1) (img 2.2)
NOTE: If you see
this plug has
been installed
DO NOT remove
until you have
verified probe is
in place.
SEE NEXT PAGE
3