Preparing SpaBoy® Probe - Plug installed
(img 2.3)
If the plug has been installed (img 2.3) there is a
possibility that the SpaBoy® probe was not installed upon
delivery due to cold weather or the spa not being filled and
turned on for an extended period of time.
(Img 2.4)
To verify the probe has been installed Please open the
cabinet door behind the probe housing to confirm you can
see the back of the probe (img 2.4).
4
(Img 2.5)
Once you have verified the probe has been successfully
installed, you need to ensure it is connected to the
generator. The wires attached to probe are labelled ORP
and pH. Attached to the corresponding fitting on the
generator (img 2.5). Insert the wire end giving a turn
clockwise to ensure connection is secure.
To Next Page
Loading...