Important: Trays are to only be in
for a 24 hour period leaving them
in longer may reduce the
effectiveness of filtration. When
the weirs float above the filters
this is a good indicator the trays
need rinsed or replaced.
Step 3: Installing the filters - Progessive Filters
MODEL
LEFT SIDE
RIGHT SIDE
Arctic Fox Standard Hi Flow
Cub Standard Hi Flow
Yukon Standard Hi Flow
Frontier Standard Hi Flow
Kodiak Hi Flow Standard
Klondiker Standard Hi Flow
Summit Standard Hi Flow
Tundra Standard Hi Flow
Summit XL Standard Hi Flow
Ocean Standard Hi Flow
Okanagan Standard Hi Flow
1. Your new Custom Series Arctic Spa comes equipped with 2 new Progressive Filters.
One filter is a High Flow and the other is a Standard Flow (img 3.1). To determine
which side the filters belong locate you model on the chart below.
2. Inserted in the top of both filters you will find a filter tray (img 3.2). This tray is
designed to remove impurities in your source water. After 24 hours remove the filter
trays rinse, and leave out. They can be used again on your next fill.
(img 3.1)
Left Side Right Side
(img 3.2)
Filter placement is determined by standing outside the
spa directly behind the filter canisters and looking down
over the waterfall onto the filter canisters
5
To Next Page
Loading...