Before using the Appliance
1. Install the Appliance on a firm and even floor/desk
• Install the Appliance on a level floor/desk.
• The front side of Appliance should be approximately 1cm higher than
the back side. Use the adjustable feet to change the level of the front
side.
2. Position the shelves and clean the inside of the Appliance
• Set the shelves at the desired height, and clean the inside with a soft
and damp cloth.
3. Connect the Appliance to an exclusive power outlet
• Use an exclusive power outlet for the Appliance. Do not cut and shorten
the power cord, do not use extension cords, and do not use any
electrical outlet divider.
• Use the correct power supply as indicated on the product label placed
on the back of the Appliance. (AC230V, 50Hz,Single phase) Make sure
the voltage of the power source meets the specified voltage, ±5%. If
you have voltage stability problems in your area, use a voltage
stabilizer.
4. Before storing anything, make sure the inside of the Appliance is fully
cooled down
• The plastic odour will disappear once the Appliance cools down.
If the Appliance is transferred to a new location, and the move takes less than 1 hour, the power
supply can be switched on immediately. (Please note that it should not be switched on at least for
10 minutes after it is switched off.) If the transfer takes more than 1 hour, please leave the
Appliance unplugged for at least 48 hours with the door open before restarting it.
Warning/Caution
Do not put bagged ice packs (including those containing ammonium nitrate, and urea) in the Appliance. Leakages
from such bags may cause rust or breakdown of the Appliance.
Do not place any form of volatile substance or inflammable, such as ether, benzine, alcohol, propane gas, glue,
etc. inside the Appliance. Failure to follow these instructions may lead to explosions or fire.
Any type of bottle or can containing liquid that can be frozen should never be stored in the Appliance since the
bottles and cans may explode. This can lead to personal injury.
Do not touch stored materials, containers (especially metallic ones), or the inside of the Appliance with bare or
wet hands. Failure to follow these instructions may lead to frostbite. Make sure to wear gloves when working.
Power sourse:
AC 230 V, 50 Hz
Single phase
Please wait
for about 2 - 3
hours
8
To Next Page
Loading...