EasyManua.ls Logo

Arctiko MUF 40 - Page 7

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installing the Appliance
Installation should only be performed by a qualified expert from the sales agency or elsewhere.
Imperfect installation may result in water leakage, electrical leakage, electric shocks, or fire.
Choose an area with low levels of both heat and moisture.
The cooling performance of the Appliance may be adversely affected if it is placed in direct sunlight
or near a source of high temperatures.
If moisture or water comes into contact with the Appliance, it may be a cause of poor electrical
isolation or rust.
Allow adequate space around the Appliance
Lack of space may cause poor cooling performance, breakdown of the Appliance, or overuse of
electricity.
Allow at least 5cm from the back wall of the Appliance, and also at least 5cm from the sidewalls.
There should be a space of at least 10cm between the top of the Appliance and the ceiling. There
are air vents on the top of the Appliance in the back. Do not place anything on the air vents.
Install the Appliance on a firm and level floor/desk
To stabilize the Appliance turn the adjustable feet clockwise until they make firm contact with the
floor/desk (see figure above, right).
If the Appliance is not stabilized correctly, it may cause unusual noises and vibrations.
Ground the Appliance to prevent electric shocks
The power plug used on this Appliance comes with a ground. Make sure to use an earthed power
outlet. Imperfect grounding may lead to electric shocks.
If there is no existing earthed power outlet, it will be necessary to have one installed by a qualified
electrician.
Do not connect the grounding conductor to the following objects.
Water or gas pipes (This may cause explosions or fire.)
Lightning rods or phone cables (This may cause serious injury or death if lightning strikes.)
Electric Leakage Breaker
If installation in a damp area is unavoidable, the use of an electric leakage breaker is strongly
required.
Electrical connection must be made in accordance with the local regulations
Back wall
From sidewalls
,T,f,•
,T,f,•
,P,O,f,•
Turn the adjustable feet in the direction of
the arrow for correct installation.
7

Related product manuals