16
GBInstructions for use
ASSEMBLY INSTRUCTIONS
Assembly kit composed of: 4 screws - 4 wall plugs.
WALL INSTALLATION
Fix the four plugs to the wall taking into consideration that the distance
between them must correspond to that between the four hanging holes
on the back of the appliance. Tilt the main body down and unscrew the
screw placed on the top of protective ap; tilt the main body up and
unscrew the screw placed on the bottom of the protective ap. Position
the main body in straight position (not tilted neither up nor down) and take
out the protective ap from the xing plate. Place the product to the wall
taking care that the hanging holes correspond with the holes in the wall
and x the product using the screws provided. Replace the protective ap
and secure it with the two screws previously removed.
The appliance must be installed at least 1,80m above the ground
and 15 cm from the ceiling.
Operation.
Before connecting or disconnetting the appliance, make sure that the
product is in o position (power indicator show “0”).
To turn the appliance on put the plug in the socket and select the desired
power by pull the cord switch: power 1 (600W) and power 2 (1200W).
The selected power is shown in the power indicator window.
To turn the product o the power indicator must be in “0” position.
GBMaintenance
This appliance does not require any special maintenance.
Disconnect the plug from the socket and let the appliance cool down well
before cleaning it.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from
entering into the apparatus and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
17 / 46
To Next Page
Loading...
