20
INSTRUCTIONS FOR THE
INSTALLER
Transport and packaging removal.
Transport the appliance carefully so as not to subject it to any impacts.
ATTENTION: Do not tilt the appliance by more than 45° or turn it upside down while
stationary or being transported.
Deliver the appliance with the original packaging and check any warnings that may be
provided on the same.
Open the packaging to remove the appliance and check that there are no signs of
damage; if any damage can be seen, do not use the appliance but contact the retailer.
Remove the adhesives used to hold the components immobile, clean the appliance
inside and out with a damp cloth and dry thoroughly.
Installation.
The appliance must be installed in a well-ventilated room.
The appliance must be positioned on a flat, horizontal, solid and stable surface. If the
appliance is unstable, adjust the support feet.
Do not position the appliance on soft surfaces.
The appliance must not be exposed to direct sunlight.
Do not install the appliance near radiators, cookers or other sources of heat.
The appliance must be installed in a place where the room temperature corresponds
with the climatic classification (shown on the data label) for which the appliance has
been designed.
N da +16°C a +32°C
To Next Page
Loading...
