ARDES AR5M40 - Page 18

18
The total operating time set before the automatic switching off is given
by the light indicators (for example if all the timer light indicators are on
during the operating time set before the automatic switching off, the total
operating time is given by:
1/2Hrs.(0,5 hours)+1Hrs.(1 hour)+2Hrs.(2 hours)+4Hrs. (4 hours)=7,5
hours).
The timer light indicators are turned off/ on according to the operating
time remained.
To disable the timer function press the button until all the operating light
indicators are off, or turn off the fan manually by pressing the Off button.
SWING
(button present both on the panel and on the remote control): press this
button to enable the automatic oscillation from right to left. The relative
light indicator is turned on, on the display. To disable the automatic
oscillation, press again the button (the related light indicator is turned off
on the display).
MIST
(button present both on the panel and on the remote control): press this
button to enable the misting. Attention: before enabling this function
make sure there is water in the tank; in case you need to add water
please see the paragraph “HOW TO FILL UP THE TANK” Once the tank
is replaced on the main body of the humidier, set the switch placed on
the side of the humidier’s main body in position “I”. The light indicator
placed on the control panel of the humidier (23) turns green. You can
adjust the intensity of the misting by rotating the adjustment knob placed
on the control panel of the humidier (23): if you rotate it clockwise the
intensity increases; if you rotate it counterclockwise the misting intensity
decreases.
The misting comes out of the knob in a few seconds after pressing the
button.
When the water is out, the misting function is disabled and the light
indicator of the adjustment knob turns red; we recommend you to disable
the misting function when the humidier is off or the tank is empty.
When the function is enabled the related light indicator is turned on, on
the display, and when the function is disabled the light indicator is turned
off on the display. The misting function can be enabled independently
from the ventilation; it is enough to turn off the fan by pressing the Off
button and then to press the Mist button.
VERTICAL SLOPE:
You can vertically point the front of the fan choosing the desired angle. It
is sufcient loosen the screw (1) under the motor, move the front of the
fan up or down according to the desired slope (2) and tight the screw.