ARDES ARSPRE01 - Technical Information

(see the image on page 2)
A – Squeezing cone
B – Filter
C – Juice conveyor
D – Pivot
E – Motor body
F – Electric plug
Technical data: see the label on the appliance.
TECHNICAL INFORMATION
7
USER INSTRUCTIONS
Contact with food
Only these parts are intended for contact with food, under the conditions indicated:
Parts intended for contact
with food
Types of food Maximum temperature Maximum time of
contact
Squeezing cone (A)
Citrus, citrus juice 40°C 30 minFilter (B)
Juice conveyor (C)
- These parts can only be used with this appliance. Do not use the parts separately for other applications.
The appliance was created and designed for use in domestic environments as indicated in the instructions. Any
other use is therefore considered improper and thus dangerous.
Do not use the appliance out of doors.
For safety reasons, the appliance should never be opened.
During use, rest the appliance on a at surface.
To prevent children from accidentally touching hot components, use the appliance on surfaces that are at least
85 cm high.
Leave space around all other surfaces of the appliance and do not cover with other objects.
Do not place the cord and the appliance near sources of heat.
Do not place the appliance above or below other appliances, ovens, microwave ovens or close to gas stoves.
WARNING: Do not use this appliance near bathtubs, showers, sinks or other vessels that contain water.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Use only the accessories supplied with the appliance.
First use.
Before using the appliance for the rst time, wash the parts in contact with food as indicated in the MAINTENANCE
paragraph.
Use of the appliance.
Assemble the accessories (see the image on page 2).
Place a suitable container in correspondence with the juice conveyor (C).
Cut the citrus fruit to be squeezed in half.
Connect to the power supply.
Press the internal part of the fruit on the cone; the motor will start up the cone will begin to rotate and the juice
will be collected in the container. Stopping pressing will also stop the motor.
Note:
- Rotation direction is random
- Do not press too hard.
- Do not leave the motor running for more than 15 consecutive seconds; wait about 15 seconds before
starting it up again.
- After 5 minutes of use, let the appliance cool down before using it again.
- To avoid leakage of juice, do not overll the container.
Disconnect the appliance from the power supply after use.
Clean the parts immediately (see MAINTENANCE) to avoid cleaning becoming difcult.