ARDESTO YCM-E1600 - CLEANING MINERAL DEPOSITS

36
NOTE: Do not clean with alcohol or solvent cleanser. Never immerse
the housing in water for cleaning.
3. Detach the metal funnel through turn it anticlockwise, get rid of
coee residue inside, then you can clean it with cleanser, but at
last you must rinse with clear water.
4. Clean all the attachments in the water and dry thoroughly.
CLEANING MINERAL DEPOSITS
1. To make sure your coee maker operating eciently, internal
piping is cleanly and the peak avor of coee, you should clean
away the mineral deposits left every 2-3 months.
2. Fill the tank with water and descaler to the MAX level (the scale
of water and descaler is 4:1; the detail refers to the instruction of
descaler. Please use “household descaler”, you can use the citric
acid (obtainable from chemist’s or drug stores) instead of the
descaler (the one hundred parts of water and three parts of citric
acid).
3. According to the program of pre-heating, put the metal funnel
(no coee powder in it) and carafe (jug) in place. Brewing water
per “PRE-HEATING”.
4. Press the ON/OFF switch to “1” position, the red lamp will be
illuminated, press the steam switch to the “0” position and the
coee/hot water selector to the “1” position, when there is water
owing out and close the pump (the coee/hot water selector
to the “0” position), and waiting for a moment, the coee maker
begins to be heated.
5. When the green lamp is illuminated, it shows the heating is nish.
Pressing the coee/hot water selector to the “1” position and
make make two cups coee (about 2Oz). Then close the pump
(the coee/hot water selector to the “0” position) and wait for 5s.
6. Press the steam switch to the “1” position, waiting for until the
green indicator is illuminated. Make steam for 2min, then turn
the steam control knob to “OFF” or “0” position to stop making
EN