ARDESTO YCM-E1600 - PRODUCING STEAM TO HEAT LIQUIDS; CLEAN AND MAINTENANCE

35
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make
hot beverages like drinking chocolate, water or tea. Method:
1. Open the tank cover and ll tank with desired water. The water
level should not exceed the “MAX” mark in the tank.
2. Replace the tank, then connecting the appliance to power supply
source.
3. Press the ON/OFF switch to the “1” position, the red lamp is
illuminated.
4. Turn the steam control knob to “OFF” or “0” position, make the
coee/hot water selector on the “1” position, the pump will
pump water, when there is water owing out, close the pump
(coee/hot water selector to the “0” position) immediately,
pressing the steam selector to the “1” position and waiting for a
moment, the appliance begins to be heated until the green lamp
is illuminated, it shows the heating is nish.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the steam
control knob in anti-clockwise slowly to start making steam.
7. When the required temperature is reached, you can turn the
steam control knob to “OFF” or “0” position.
8. Press the ON/OFF switch to the “0” position to cut the power
source o.
CLEAN AND MAINTENANCE
1. Cut o power source and let the coee maker cool down
completely before cleaning.
2. Clean housing of coee maker with moisture-proof sponge often
and clean water tank, drip tray and removable shelf regularly then
dry them.
EN